Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
06-04-2002, 11:18 PM
|
#1 |
|
Registered Member
Join Date: Oct 2001
Location: Joosey Shore
Posts: 358
|
If you're going for the "clean fender look (ie..no holes) you'll have to weld a small plate on the back of the fender, fill the small little groove left behind with bondo, primer it, and then repaint the fener.
It's a real pain in the ***. I'd slap on the V6 or LX emblems you previously mentioned. Just a thought.
__________________
1988 5.0 notch: Previously never modified!!  SN95 block front and rear seats, Mac catback, BBK off-road H-pipe, Steeda castor camber plates, Steeda lowering springs, Tokico shocks/struts, Alpine/MBQuart/PPI audio mods... |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra-R Side Exhaust -- SWEEET! | SkammyManX | Modular Madness | 3 | 04-05-2003 11:58 AM |
| simple question | Lonzo | Classic Mustangs | 3 | 09-10-2002 09:37 AM |
| 25th Anniversary Question! | abesmith69 | Windsor Power | 18 | 11-20-2001 02:15 PM |
| Driver side mirror question?? | Z28EATR | Windsor Power | 2 | 09-01-2001 12:05 PM |
| battery in trunk/rear right side leaning question | LX XLR8R | Windsor Power | 4 | 03-12-2001 12:11 PM |