Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-05-2002, 06:54 AM
|
#2 |
|
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
Not the same block....The 351 is a bout 1 1/2 inch wider and about 1 inch taller....so exhaust systems need some "massaging". Heads will fit and upper intake will fit but sine the block is wider a different lower manifold will need to be used. Headers will not swap and you will also need a different oil pan. Need a different distributor too.
__________________
Red 1993 GT Street Machine Best E.T. - 12.41/Best MPH = 108 Engine is a 1969 351 block w/393 stroker kit. Dynamic Roller Myte C4, 8 pt cage. Edlebrock Performer heads and Victor Jr. EFI, FRPP 30lb injectors & Cartech fuel system. MSD ignition. Sothside Machine bars & Sub-frames, adj. upper's, 3.73's, Koni rear shocks, much more |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5 lug conversion | stanger9219 | Windsor Power | 2 | 02-25-2004 11:31 PM |
| What all do you need to do rear disc conversion w/ SN95 Parts | KG88GT | Windsor Power | 1 | 07-29-2003 01:45 PM |
| questions about maf conversion | spankaveli | Windsor Power | 10 | 10-19-2002 02:46 PM |
| 5 to 4 lug conversion | mike_navigator | Blue Oval Lounge | 7 | 08-14-2002 11:17 PM |
| mass air 87GT conversion | greydan | Windsor Power | 3 | 01-02-2002 07:57 PM |