Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
06-06-2002, 11:34 AM
|
#1 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
Wires from the MSD box go to the following:
Heavy Red: To Battery Pos. Heavy Black: To Battery Ground Thin Red: To Pos Coil Wire Thin White: To Neg Coil Wire Thin Orange: To Pos Coil Thin Black: To Neg Coil The thin red wire does not touch the coil directly after the box is installed. It goes through the box to reach the coil. Joe50- Double check your grounds. If they're good, and you have voltage at the thin red wire, but no voltage at the thin orange wire, then the box is defective. Take care, -Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edelbrock RPM intake install problems | jruppert | Windsor Power | 4 | 03-04-2004 05:05 PM |
| HELP: Problems after Paxton Novi 1000 install | Meatman | Windsor Power | 3 | 10-17-2002 06:03 PM |
| Having problems with vibrations after clutch install Please help. | zepherman | Windsor Power | 6 | 05-17-2002 10:15 AM |
| problems with mac longtube install | NotchJohnson | Windsor Power | 13 | 12-08-2001 09:51 PM |
| Cold starting problems after Novi 2000 install. | DCON | Windsor Power | 1 | 04-10-2001 10:02 AM |