Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-08-2002, 06:24 PM
|
#4 |
|
Registered Member
Join Date: Jun 2000
Location: Nor-Cal
Posts: 1,311
|
I have an auto GT too. Here's how it works: Install an Xpipe, C&L 80mm MAF kit, and pulleys. That will make your car pull through the RPM range much easier. Next, throw some 4.10 gears and a chip in. At this point, you will enjoy your auto very much
 Good luck.
__________________
Black 2000 GT Auto V2-SQ, Full Steeda G-trac Suspension, Baer Brakes, Saleen Body Kit, Corbeau CR1s, Chrome Cobra R's, etc, etc... 341rwhp, 338 torque 1994 Cobra #4343 Bolt on's only... Cofounder of Raccoon Racing Last edited by StoplightWarrior; 06-09-2002 at 01:11 AM.. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| K Member | 65,dohc,project | Classic Mustangs | 0 | 10-06-2004 03:27 PM |
| tubular k member/ motor mounts? | sn95gt19 | Windsor Power | 0 | 12-04-2002 12:05 PM |