Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
06-09-2002, 08:57 PM
|
#1 |
|
Registered Member
Join Date: Jan 2001
Location: Clayton, CA USA
Posts: 116
|
I picked up a new regulator from Auto Zone for $10. The volts look OK at around 15v. Now I need to get a new constant voltage unit and see if that fixes the problem.
All my wires look OK. The only thing that may have been a problem was the starter wires were on the headers and melted the plastic coating. I re-routed these and they should be fine now. Thanks for the advice Rev. I'm hoping that fixes it. I want to get this motor broken in so I can get to the track.
__________________
'68 convert, 5.0 GT-40 Crate motor, C-4, Tri-Y headers, 3.25 rear gears |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4.6 short block | zach0 | Modular Madness | 1 | 03-09-2003 11:48 PM |
| Need advice on where to buy a 302 short block. | yelowjaket | Blue Oval Lounge | 1 | 01-03-2003 01:17 PM |
| tricks to find vacuum leak | fiveohpatrol | Windsor Power | 5 | 10-03-2002 06:15 PM |
| Cant find a Damn T5. Help !!!!!!! | Mercury | Blue Oval Lounge | 4 | 04-14-2001 10:49 PM |
| Where can I find a custom gauge bezel?! | BossGuy | Classic Mustangs | 0 | 03-17-2000 04:04 PM |