Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-11-2002, 10:08 AM
|
#3 |
|
Registered Member
Join Date: Aug 1999
Location: Fairfax, VA
Posts: 220
|
You need a 1/16" Male to 1/8" Female fitting. The 1/16" goes where the schrader valve is (remove the valve after you have released the fuel pressure) - and the gauge sender will screw into the 1/8" female end.
If you didn't get it when you bought the gauge (like me) you will spend more on shipping & handling than the cost of the part (like me). Unless you have a decent shop or HW store near you that carries them...
__________________
1992 LX 5.0 Convertible Red/Blk Gears, Exhaust, bolt-ons... R.H.C. #51 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Autometer electric FP gauge install question | Mike Souslin | Windsor Power | 0 | 06-24-2002 05:44 PM |
| Fuel pressure at high altitude. etc... | Dark_5.0 | Windsor Power | 5 | 04-19-2002 07:52 AM |
| fuel pressure and bad injectors??? | wrathchild | Windsor Power | 1 | 10-02-2001 06:40 AM |
| New motor no fuel pressure? Help please | 92Rustang | Windsor Power | 1 | 08-01-2001 04:15 PM |
| Installing a fuel pressure regulator | moponys | Windsor Power | 7 | 07-20-2001 09:36 PM |