Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-11-2002, 03:29 PM
|
#18 | |
|
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
I was told by the guys at Dynamic Racing that the idle should be around 850-900. Harold @ Dynamic said it's just harder on the tranny internals to go from park to drive and drive to reverse @ higher idle speeds. But after what they did to the tranny on the dyno (it was amazing to watch) I find it hard to believe that ANYTHING under 900 HP would hurt this tranny.
Quote:
__________________
Red 1993 GT Street Machine Best E.T. - 12.41/Best MPH = 108 Engine is a 1969 351 block w/393 stroker kit. Dynamic Roller Myte C4, 8 pt cage. Edlebrock Performer heads and Victor Jr. EFI, FRPP 30lb injectors & Cartech fuel system. MSD ignition. Sothside Machine bars & Sub-frames, adj. upper's, 3.73's, Koni rear shocks, much more |
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Throttle Body & Idle Conrol Valve Info | BigBobsL | Windsor Power | 2 | 02-10-2004 01:16 AM |
| Bbk/edelbrock Throttle Body Sticking | sn95gt19 | Windsor Power | 4 | 06-25-2002 02:01 PM |
| 99-01 Gt Throttle Body 70mm Stock? | steedamustang01 | Modular Madness | 5 | 04-17-2002 11:54 PM |
| Will A Throttle Body Do Much For Ya With Minor Mods? | steedamustang01 | Modular Madness | 15 | 04-15-2002 10:38 PM |
| Throttle Body | 96Saleen | Modular Madness | 1 | 08-22-2001 11:00 AM |