Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-12-2002, 11:14 AM
|
#5 |
|
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
Windsor is just the name of the city where the engine's were built. Obviously, the 351 Cleveland's were built in Ohio. As far as the swap goes, a lot depend on if you are running EFI or a carb. EFI will cost a lot more. I put a 393 in my car and needed to get new oil pan, headers, distributor, etc. The h-pipe needed to be bent to accomodate the extra 1.5 in. of engine width. I also needed to get a EFI 351 lower base to match the Edelbrock upper plenum and a hood to accomodate the extra inch or so of engine height. The biggest decision you need to make is if you are going to go EFI or carb. Good luck!
__________________
Red 1993 GT Street Machine Best E.T. - 12.41/Best MPH = 108 Engine is a 1969 351 block w/393 stroker kit. Dynamic Roller Myte C4, 8 pt cage. Edlebrock Performer heads and Victor Jr. EFI, FRPP 30lb injectors & Cartech fuel system. MSD ignition. Sothside Machine bars & Sub-frames, adj. upper's, 3.73's, Koni rear shocks, much more |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Throttle Body & Idle Conrol Valve Info | BigBobsL | Windsor Power | 2 | 02-10-2004 01:16 AM |
| Throttle body to carb conversion | Budiak | Classic Mustangs | 3 | 07-02-2002 02:04 AM |
| Saleen Body Kits - good or bad? | subterfuge | Modular Madness | 5 | 06-26-2002 10:55 AM |
| Any body in Orlando that does paint and body work?PEASE read | robertwigton | Windsor Power | 0 | 12-18-2001 02:15 AM |
| Throttle Body | 96Saleen | Modular Madness | 1 | 08-22-2001 11:00 AM |