Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-20-2002, 07:37 AM
|
#3 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
I agree that the MM brace is by far the best one on the market.
If you wanted to make uninstallation quicker you could insert the bolt from the underneath and tack weld it in place. Then you can take the brace on or off without a second wrench. Make sure you drill all of the holes and tighten everything BEFORE you weld so you can be sure everything lines up. You can put rubber covers, similar to vacum caps on the ends of the studs top make it look more presentable. Good luck.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Strut Tower Brace | saleen243 | Windsor Power | 1 | 02-18-2003 04:52 PM |
| Help! Strut Tower Brace - Will it fit w/this intake? | daveGT | Windsor Power | 5 | 08-05-2002 04:24 PM |
| To strut tower or not to strut tower? | mysweetlx | Stang Stories | 9 | 05-06-2002 12:10 PM |
| caster/camber plates used with a strut tower brace | jtl | Windsor Power | 1 | 02-10-2002 10:31 PM |
| strut tower brace | BLK99GT | Modular Madness | 4 | 05-12-2000 06:14 PM |