Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-20-2002, 02:40 PM
|
#7 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
I highly recommend weld in sub frame connectors. If you get the bolt on, like Steeda, weld them on instead of just bolting them up.
The MM connectors are very good as are the "super sub frame matrix" that is made by Kenny bell.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sub frame connectors | 84GT350-1 | Windsor Power | 9 | 05-31-2004 10:07 AM |
| Sub frame connectors, roll cage ????? | 84GT350-1 | Windsor Power | 3 | 05-11-2004 09:59 AM |
| Sub Frame Connectors | TwiLighTBluEGT | Windsor Power | 9 | 08-12-2002 09:30 AM |
| sub frame connectors | mellow yellow | Windsor Power | 5 | 02-19-2001 09:53 AM |
| Frame connectors | Ember | Classic Mustangs | 1 | 06-25-2000 05:51 PM |