Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-21-2002, 03:53 PM
|
#12 |
|
Tubbed and Juiced
Join Date: Mar 2001
Location: Tulsa, Oklahoma
Posts: 1,861
|
MM&FF did a test on a mustang with around 300hp, they swapped back and forth from a 65mm to a 70mm, and there was no difference in power, no loss, no gain. If I was to buy a Throttle body right now it would be a Holley 70mm. I had a BBK 70mm, it made the throttle sticky, not smoothe, and made driving a hassle.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| Low, loppy idle then too high, then low again.... | Fox Body | Windsor Power | 6 | 08-05-2003 11:29 PM |
| 306 street fighter from Coast High. short-block | yelowjaket | Windsor Power | 2 | 05-15-2003 06:02 PM |
| Fuel pressure at high altitude. etc... | Dark_5.0 | Windsor Power | 5 | 04-19-2002 07:52 AM |
| Cobra, Edlebrock, GT40, Mac, Explorer Intakes | Gautam | Windsor Power | 7 | 02-07-2001 10:37 PM |