Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-21-2002, 06:28 PM
|
#3 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
It's easy enough to do with a helper. If you leave the transmission attached, the engine will naturally tilt down on the transmission end.
I've done all my pulling with a chain hoist. Just make sure you check and make sure all the connections have been removed. I like to make sure the engine is moving freely every few inches or so. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine transplant across decades and models. | Sketch | Classic Mustangs | 6 | 04-18-2004 07:51 AM |
| Reply To J-Spec Engine Question | 1BadMoFo5.0 | Blue Oval Lounge | 2 | 05-09-2001 09:30 AM |
| 3.8 engine questions | MY PRIZE | Modular Madness | 2 | 01-19-2001 07:28 AM |