Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
06-25-2002, 08:12 PM
|
#1 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
Could be a piston, too. Ground out the plug wires one at a time until the noise almost goes away. Then you will know which cylinder it is. Next, pour several ounces of 40 weight engine oil into the cylinder. crank the engine over several times with the coil disconnected. Instal the plug, and start the engine. If the noise is gone, it's a piston slap, or a collapsed skirt. If the noise remains, it's a rod.
Take care, -Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| First ticket. Sucks, sucks bad. | zepherman | Blue Oval Lounge | 46 | 12-16-2001 07:24 PM |