Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-30-2002, 05:49 PM
|
#2 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
It probably means that the engine was bored .060 over when it was rebuilt. Thats the max you can bore the engine. If you ever get head gaskets, make sure they are for .060 overbored pistons.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Piston Ring Install Question | rancheroo | Windsor Power | 3 | 02-20-2004 10:07 PM |
| Speed secret # 5 | jim_howard_pdx | Windsor Power | 37 | 11-15-2002 12:19 PM |
| Piston Speed | richd | Windsor Power | 1 | 10-12-2002 10:11 AM |
| valve seal vs piston ring oil leak. | thdrcat | Classic Mustangs | 2 | 07-30-2002 07:06 PM |
| Please - I need advice on piston to valve clearance ASAP | 2FastLX | Windsor Power | 8 | 03-18-2001 03:05 PM |