Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-01-2002, 03:04 PM
|
#1 |
|
Registered Member
Join Date: Oct 1998
Location: Az
Posts: 854
|
they wont move... use a sealer or loctite on the studs... they go into the water jacket... rpm wont matter... if the guide plate comes loose... it will be because the rocker stud is loose...
or get a different set of guide plates...
__________________
84 convt,roller 302,AFR's, performer 3.55's, underdrives BBK shorties stock cam, 1.7's 13.58@102.84 and a '68 stang .. project 8 sec street car... 557 big block + N20 :-) http://members.cox.net/darkknight302/68nwrear.jpg |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pressure plate install, quick question | bmxmon | Classic Mustangs | 1 | 06-02-2004 03:44 PM |
| question, plz read | TwiLighTBluEGT | Windsor Power | 1 | 11-05-2002 04:01 PM |
| injector question please read | james87gt | Windsor Power | 1 | 10-12-2002 10:44 AM |
| TFS Guide Plate Alignment??? Thanks! | jseaton | Windsor Power | 0 | 11-04-2001 05:58 PM |
| Important Exhaust Question - Please Read | sublimelax | Small Ponies | 14 | 03-06-2001 10:14 PM |