Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-03-2002, 03:41 PM
|
#6 |
|
Registered Member
Join Date: Oct 1998
Location: Az
Posts: 854
|
well, my 7.5 lasted for a LONG time... sitting out in the garage because one of the bearings was going south...60+ 1/4 passes and driving every day... if you dont plan on running DR's or slicks... the 7.5 should hold up fine...
there are ALOT of cams for the early 302..any Hyd. cam will work.. I got BBK ceramics for my 84... crossmember... etc.. the only HARD part is putting a mount for the rear hangar on the drivers side.. probably a performer intake if you need to pass smog.. if you want to keep the EGR... 600 holley...
__________________
84 convt,roller 302,AFR's, performer 3.55's, underdrives BBK shorties stock cam, 1.7's 13.58@102.84 and a '68 stang .. project 8 sec street car... 557 big block + N20 :-) http://members.cox.net/darkknight302/68nwrear.jpg |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Are all 8.8 rears the same? | 82 GT | Windsor Power | 29 | 08-23-2004 01:06 PM |
| Tips on buying an 87 GT(is it really a GT?) | LincoConti87 | Windsor Power | 9 | 07-23-2004 08:08 PM |
| '02 GT Drop top Vs. '94 Cobra | EZRIDN | Stang Stories | 3 | 03-26-2004 04:23 PM |
| Newbie with 86 GT questions | Umoplata | Windsor Power | 16 | 11-22-2001 10:29 AM |
| Best 1 5/8" headers?? Watcha got, need input! | Bob | Windsor Power | 4 | 01-10-2001 08:03 AM |