Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-15-2001, 12:02 PM
|
#7 |
|
Registered Member
Join Date: Sep 1999
Location: Deltona Fl
Posts: 140
|
2031 here, and I love it. It idles just rough enough to sound mean, but smooth enough to run an auto trans(needs a stall though). My only gripe is that I needed longer pushrods.
------------------ 90LX Ragtop. 14.7@95.3 Strut tower brace, K&N, 2.25'' Flowmasters, Hollow cats, Crank pulley, Crane 2031, Crane rockers, Holley FPR, 155lph, Heavy duty clutch, and alum quadrant. Need Gears Bad!!! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| E303 vacuum? | Nixon1 | Windsor Power | 17 | 07-16-2003 08:02 PM |
| 50 HP Cam Swap? Replace E303 with Comp XE270 | NO SLO PK | Windsor Power | 2 | 07-01-2003 04:52 PM |
| E303 with this setup | stng87 | Windsor Power | 3 | 03-14-2001 08:26 PM |
| New 2031 cam, idle questions | withamc | Windsor Power | 5 | 02-26-2001 11:36 AM |
| Putting in 2031 Saturday | withamc | Windsor Power | 7 | 02-17-2001 11:00 PM |