Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-16-2002, 01:03 PM
|
#3 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
Kenny brown makes one. It would only be useful in an all out racecar, but then the roll cage could be biult into the rear shock towers. It also looks like a pain to install and takes up too much room.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Shock Tower? Dry popping or cracking sound? | 66mustanger | Classic Mustangs | 3 | 07-01-2004 10:18 PM |
| Shock Tower? Dry popping or cracking sound? | 66mustanger | Classic Mustangs | 0 | 06-30-2004 07:49 AM |
| Strut Tower Brace | saleen243 | Windsor Power | 1 | 02-18-2003 04:52 PM |
| caster/camber plates used with a strut tower brace | jtl | Windsor Power | 1 | 02-10-2002 10:31 PM |
| Saleen Rear Shock Tower Brace | 97snakedriver | Corner Carvers Delight | 2 | 09-07-2000 12:53 AM |