Injector size & 347 stroker question????

Smokedawg · 05-25-2001, 12:35 PM

Besides the heating problem i love my 347..I think those 36lb injectors will be a bit much for ya...I would go with 30's and even if you got a supercharger you could bump up your adj fuel reg. enuogh to hold that...I would also be careful with your cam selection..It takes a good power cam to have these motors to get to their potential. I would have a cam specially ground to fit your motor!
Good Luck

------------------
347 Stroker Motor: Balanced, A9P Computer, Cobra Transmission, Extrude Ported and Polished Upper and ported Lower, GT40 Milled Ported and Polished Heads, B303 Cam, BBK 1 5/8 Headers, 30lb Bosch Injectors, Holley Fuel Regulator, March Underdrive Pulleys, Perma-Cool Fan, 3-Core Radiator, Accel Performance Coil, Accel 300+ Racing Wires, Ram Air, K&N Filter, 79mm Mass Air Unit, FlowMaster Exhaust w/BBK Offroad H-Pipe, Hurst Short Throw Shifter, 3:55 Gears, Ram Clutch, Cross Drilled Rotors, AC del

[This message has been edited by Smokedawg (edited 05-25-2001).]

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Blown Stroker Computer Help	RabidPony	Modular Madness	10	02-07-2004 11:56 PM
Question for stroker guys	moponys	Windsor Power	7	01-16-2004 10:46 AM
'super' stroker vs 'budget' stroker	mike5p01	Windsor Power	4	10-11-2003 10:11 PM
stroker engine question	82 GT	Windsor Power	1	06-08-2001 03:22 PM
windsor stroker computer question	gon4x4n	Windsor Power	4	02-16-2001 07:23 AM

05-25-2001, 12:35 PM	#1
Smokedawg Tires Fear Me... Join Date: Jan 2001 Posts: 867	Besides the heating problem i love my 347..I think those 36lb injectors will be a bit much for ya...I would go with 30's and even if you got a supercharger you could bump up your adj fuel reg. enuogh to hold that...I would also be careful with your cam selection..It takes a good power cam to have these motors to get to their potential. I would have a cam specially ground to fit your motor! Good Luck ------------------ 347 Stroker Motor: Balanced, A9P Computer, Cobra Transmission, Extrude Ported and Polished Upper and ported Lower, GT40 Milled Ported and Polished Heads, B303 Cam, BBK 1 5/8 Headers, 30lb Bosch Injectors, Holley Fuel Regulator, March Underdrive Pulleys, Perma-Cool Fan, 3-Core Radiator, Accel Performance Coil, Accel 300+ Racing Wires, Ram Air, K&N Filter, 79mm Mass Air Unit, FlowMaster Exhaust w/BBK Offroad H-Pipe, Hurst Short Throw Shifter, 3:55 Gears, Ram Clutch, Cross Drilled Rotors, AC del [This message has been edited by Smokedawg (edited 05-25-2001).]