Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-27-2002, 10:54 AM
|
#5 |
|
Registered Member
Join Date: Jan 2002
Location: Mt. Prospect,IL
Posts: 474
|
i am looking into, infact buying the gt 40 long block motor from downsford, it sells for 3095.00. I am going to install it with my dad and a few buddys. They claim that it has 345hp with ford induction i am not sure what intakes though, they dont state that but. the motor comes with a b303 cam or a e303 cam you get to choose. The motor really comes with everything but intake exaust throtle body. i am not sure if that helps but that is a sugestion
-raini
__________________
87-ford-mustang-SOLD! mods: 3:73's, off road h-pipe, b303 cam in gt- 40 motor w/ Power Plus intake, edelbrock 70mm tb & egr spacer, 72mm C&L, bbk long tubes, tremec tranny, centerforce dual friction clutch, upr and lwr CA's 255lph FP and soon more to come.... when i have money again SOME ADVICE Don't do burn outs in reverse it is very expensive New times with dead hook on dr's 13.27@103 with 2.0 60 foots w/100lb system Fastest time to date: 12.8@113 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Built Motor? Questions | Rosco | Windsor Power | 1 | 10-22-2003 01:12 AM |
| Rebuilding an engine.. and then some | Halz | Windsor Power | 5 | 04-01-2002 02:01 AM |
| $1000 to spend on motor ne suggestions | topnotch8 | Windsor Power | 4 | 03-31-2002 02:02 PM |
| What year and type of motor do I have.. | Smokedawg | Windsor Power | 18 | 08-15-2001 05:08 PM |
| GT-40p headed motor | 89 Cobra LX | Windsor Power | 5 | 06-15-2001 06:46 PM |