Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-27-2002, 01:35 PM
|
#1 |
|
Registered Member
Join Date: May 1999
Location: Georgia
Posts: 3,866
|
The way I see it, the guy was missing ONE dowel pin and wanted to know if he can put his head on without it. I say yes, and I still say yes.
Im not saying its the best way, and I never did, but you can do it and your car will run without problems. When all 10 head bolts are centered and torqued, and all are going through the gasket where they should be, and you are careful that everything is lined up correctly, and you have ONE dowel pin, as he said he did, I say he can do it. Am im right. He can do it. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Talk about a bump on the head...(please read, important) | mustangman65_79 | Blue Oval Lounge | 15 | 09-05-2003 02:43 AM |
| which head for the 4.6L? | ac97gt | Modular Madness | 36 | 07-28-2003 02:48 PM |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| head gasket replacement stuff questions | fiveohpatrol | Windsor Power | 4 | 04-13-2001 04:23 PM |