Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
07-27-2002, 08:30 PM
|
#1 |
|
Registered Member
Join Date: Oct 1999
Location: Stuart, FL US
Posts: 192
|
i just removd the heads from my engine to get them overhauled. Mainly cleaned up. But anyway. there were no dowel pins in the assembly.The builder did use studs for mounting the heads though. I don't know if this would sufice for the dowle pins or not?
Should i put some new pins in?
__________________
90 LX 5.0 ,bored 302, MSD 6AL, Twisted Wedge TrickFlo HDs, World class T5, BBK fender cold air induct., 70mm TB,Edelbrock performer Intake, aluminum Drve shaft, 3.55 Gears, Long Tube Headers to Flowmasters. |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Talk about a bump on the head...(please read, important) | mustangman65_79 | Blue Oval Lounge | 15 | 09-05-2003 02:43 AM |
| which head for the 4.6L? | ac97gt | Modular Madness | 36 | 07-28-2003 02:48 PM |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| head gasket replacement stuff questions | fiveohpatrol | Windsor Power | 4 | 04-13-2001 04:23 PM |