2 questions

Kisner · 07-30-2002, 07:53 PM

The hood and trunk letters on the 67 are mounted via holes and held by barrell nuts. Don't know of any templates available since I also looked for a trunk letter template for my 68. However, I do have a back issue of "Mustang Monthly" magazine I held on to that lists exact placement of the letters. I can dig it out and give you the exact locations of where the letters should be if you like. It doesn't measure where to drill the holes but measures from the left side of the hood and trunk lid to the left side of where each letter should be.

One recommendation I would make (my 2 cents) is to not drill the holes on the trunk lid. The early model Mustang trunk lids were notorious for rusting out right behind the bottom lip of the lid where the letters are mounted. Primarily because the holes eventually allowed water in to settle in the lower cavity. Mine was so rusted out I had to purchase a new trunk lid and have decided to use the stick-on letters instead (they're identical to the push in type). In addition, it was going to be a nightmare for me to drill 2 holes per letter and pray each one was perfect.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Just got a 98, have some questions?	98GTNewbie	Modular Madness	5	08-30-2003 12:41 AM
Quick questions on Explorer Intake install.	Falcons Talon	Windsor Power	2	08-21-2003 12:40 PM
Several questions about oil.	zepherman	Windsor Power	3	08-03-2002 06:59 AM
HELP! Newbie 95-96 GT questions	Ron Brooks	Blue Oval Lounge	7	07-11-2001 07:38 PM
S/R Questions	DAMION	Racer's Club House	1	09-30-1999 11:02 AM

07-30-2002, 07:53 PM	#1
Kisner Registered Member Join Date: Nov 2000 Posts: 290	The hood and trunk letters on the 67 are mounted via holes and held by barrell nuts. Don't know of any templates available since I also looked for a trunk letter template for my 68. However, I do have a back issue of "Mustang Monthly" magazine I held on to that lists exact placement of the letters. I can dig it out and give you the exact locations of where the letters should be if you like. It doesn't measure where to drill the holes but measures from the left side of the hood and trunk lid to the left side of where each letter should be. One recommendation I would make (my 2 cents) is to not drill the holes on the trunk lid. The early model Mustang trunk lids were notorious for rusting out right behind the bottom lip of the lid where the letters are mounted. Primarily because the holes eventually allowed water in to settle in the lower cavity. Mine was so rusted out I had to purchase a new trunk lid and have decided to use the stick-on letters instead (they're identical to the push in type). In addition, it was going to be a nightmare for me to drill 2 holes per letter and pray each one was perfect.