Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-01-2002, 03:02 PM
|
#6 |
|
Don Corlione
Join Date: Jun 2001
Location: Omaha NE USA
Posts: 491
|
If money is a major concern, try checking out some of Trick Flows intakes. They flow just as well if not better than the Edelbrocks but cost a little less.
With your combo, I would expect a better intake to put you in the 11s. 5.0 Mustang and Super Fords just did an intake dyno comparison and they were picking up 15+ hp with the one of the Trick Flow intakes over the Cobra. Plus you'll successfully move your powerband up a few hundred rpms. Your combo will like that. Do your heads have the 1.9 or 2.02 intake valves?
__________________
Eric - 89 Mustang LX coupe 5 speed 302-Cobra Intake-GT40p heads-TFS stage 1 cam-FRPP 1.6 roller rockers-3:73 gears-KYB shocks and struts-Eibach Pro-kit-HPM Mega-bite upper and lower control arms-FRPP aluminum driveshaft-16x8 Chrome Cobra Rs R.H.C. #14 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| Low, loppy idle then too high, then low again.... | Fox Body | Windsor Power | 6 | 08-05-2003 11:29 PM |
| high rise manifold | fordkid68 | Classic Mustangs | 2 | 05-18-2003 01:38 AM |
| 306 street fighter from Coast High. short-block | yelowjaket | Windsor Power | 2 | 05-15-2003 06:02 PM |
| Fuel pressure at high altitude. etc... | Dark_5.0 | Windsor Power | 5 | 04-19-2002 07:52 AM |