headers are a pain!

[fiveohpatrol]

Originally posted by Unit 5302:
If those are the 1 5/8" equal lengths, I hate to be the bearer of bad news, but I wouldn't expect more than 5hp.

Your car doesn't need the extra flow that the equals will provide, and they'll rob a good deal of low end torque.

Honestly until you get some mods, you'll be much better off with the stockers. Even though they look like *** , they are not the bottleneck you want to address in the exhuast. That is your factory H-pipe. Swapping that with a hiflow unit could net you an honest 15hp.

...ditto

------------------
88 Notch, 3.73's, Ported E7's, Explorer int. w/ ported lower, pulleys, 1.7RR's, BBK headers, off-road H-pipe, flowmasters, subframe connectors, 65mm TB, shift kit, March ram air ,MSD coil, U/L control arms, 155lph fuel pump, cheap 2800 stall, Crane Adj.FPR, best 1/4--> 13.77@101.35