Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-09-2002, 01:40 PM
|
#7 |
|
Registered Member
Join Date: Mar 2000
Location: Springfield, Ma, usa
Posts: 706
|
You have to take all the accessories off the front. They all bolt to the heads, not just the ac and alt. Since you have never done this before I suggest you take your time and plan on having the car out commission for a few days to even a week if you encounter a major problem. You will need new head bolts, definitely! If your motor has never been apart your going to need all new gaskets. (head gaskets, lower intake gaskets, upper intake gasket, and valve cover gaskets). When you get the heads off, it might be a good idea to chase the bolt holes in the block with and under sized tap to clean them out of any crud. You will also need to borrow a torque wrench to re-instal the heads. Hope it all goes well! Good luck!
__________________
NewEngland Auto www.baystategearheads.com -91 Mustang Coupe, ex 4cyl (sold) -99 F150, 3" lift, 35" Procomps, Magnaflow exhaust |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What head gaskets and intake gaskets?? | dragstang86 | Windsor Power | 4 | 12-20-2002 04:20 AM |
| Re-using head gaskets? | Thad | Windsor Power | 11 | 08-07-2002 10:49 AM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| Head Gaskets, Header Gaskets, Intake Gaskets, etc | AxemanZZ | Windsor Power | 8 | 01-11-2001 01:09 PM |
| Boss 429 head gaskets!! | 93CobraR | Classic Mustangs | 4 | 03-13-2000 07:28 AM |