Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-09-2002, 04:34 PM
|
#9 |
|
Registered Member
Join Date: May 1999
Location: Georgia
Posts: 3,866
|
Yeah. go for it. You dont have to have new head bolts, so you can save a few dollars there if you wish. The old head bolts can be re-used with no problems, but you should at least clean them up with a wire brush or somethiing.
I think the hardest part you will have will be setting the rocker arm/valve pre-load. Not difficult, but if you have no idea what your doing, you might be scratching your head. And dont even attempt the job unless you have a decent set of quality tools. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What head gaskets and intake gaskets?? | dragstang86 | Windsor Power | 4 | 12-20-2002 04:20 AM |
| Re-using head gaskets? | Thad | Windsor Power | 11 | 08-07-2002 10:49 AM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| Head Gaskets, Header Gaskets, Intake Gaskets, etc | AxemanZZ | Windsor Power | 8 | 01-11-2001 01:09 PM |
| Boss 429 head gaskets!! | 93CobraR | Classic Mustangs | 4 | 03-13-2000 07:28 AM |