How to reset the computer in my 90GT

[PKRWUD]

After you finish setting them, you then reset your ECM. You should also do the following relearn procedure:

After resetting the ECM,

1) Start the engine, and allow it to idle for 1 minute.
2) Shut it off, and wait 10 seconds.
3) Start the engine, and turn on the headlights on high, and your a/c, with the fan on high, and let it idle for 1 minute.
4) Turn all the accessories off, and turn the engine off, and wait 10 seconds.
5) Start the engine, and make it idle @ 2000 rpm for 1 minute.
6) Shut it off, and wait 10 seconds.
7) Start the engine, and turn on the headlights on high, and your a/c, with the fan on high, and make it idle @ 2000 rpm for 1 minute.
8) Turn all the accessories off, and turn the engine off, and wait 10 seconds.

This is the best way to relearn the ECM, but you should take a 10 minute test drive afterwards to make sure all is well.

Take care,
~Chris