Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
08-12-2002, 10:46 AM
|
#1 |
|
Registered Member
Join Date: Feb 2002
Location: Maryville,TN
Posts: 415
|
The 99 up heads will fit perfectly on the 96 - 98 block. The compression ratio goes up but will not effect it unless you want to go to blower or nitrous, then you have to get the piston , crank upgrades. With the higher compression I think you need to run premium gas. Also, you have to have the 99 up intake, move the oil dipstick, and heater hose. The best heads for the upgrade are the 2001 heads, they breath the best They should gain you about 50 + RWHP.
__________________
98 GT / convertable -98 Saleen engine, Saleen appearance pkg. SHM cams,P&P NPI heads, and so much more! |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| is there a visual diff. between the stock e7 and gt 40 iron heads | 93calcobra | Windsor Power | 3 | 11-05-2002 09:58 AM |
| will 99-2002 cams out of the pi heads fit in the 96-98 stock heads | slow98 | Modular Madness | 6 | 10-25-2002 04:28 PM |
| 351W heads on 289? | 66 Racer | Classic Mustangs | 4 | 10-18-2001 03:12 AM |
| How about GT-40 heads? | SlowStang2 | Windsor Power | 3 | 07-03-2001 02:02 PM |
| is there any difference between 351C heads and 351M heads | tireburner163 | Windsor Power | 7 | 03-09-2001 09:26 PM |