Wanna see $100k in damage???

[PKRWUD]

Originally posted by pony_power_90
Hey Chris, What are some of the more specifics on that baby. What block base is that, piston and rod info... I I assume its totally aftermarket DUH.. but what are some of the more specifics? Cubic Inches, Stoke.

Bradley

The basic costs are:

TXF block $8000.00
Heads $8,000.00 - $10,000.00
Crank $3,500.00 - $5,000.00
Blower $5,000.00
Injector (Hat) $5,000.00
Rods and Pistons $5,000.00

Thats just for the big stuff..

Some interesting Top Fuel dragster facts:

* One dragster's 500-inch Hemi makes more horsepower then the first 8 rows at Daytona

* Under full throttle, a dragster engine consumes 1 1/2 gallons of nitro per second, the same rate of fuel consumption as a fully loaded 747 but with 4 times the energy volume.

* The supercharger takes more power to drive then a stock hemi makes.

* Even with nearly 3000 CFM of air being rammed in by the supercharger on overdrive, the fuel mixture is compressed into nearly-solid form before ignition. Cylinders run on the verge of hydraulic lock.

* Dual magnetos apply 44 amps to each spark plug. This is the output of an arc welder in each cylinder.

* At stoichiometric (exact) 1.7:1 air/fuel mixture (for nitro), the flame front of nitromethane measures 7050 degrees F.

* Nitromethane burns yellow. The spectacular white flame seen above the stacks at night is raw burning hydrogen, dissociated from atmospheric water vapor by the searing exhaust gases.

* Spark plug electrodes are totally consumed during a pass. After 1/2 way, the engine is dieseling from compression-plus the glow of exhaust valves at 1400 degrees F. The engine can only be shut down by cutting of it's fuel
flow.

* if spark momentarily fails early in the run, unburned nitro builds up in those cylinders and then explodes with a force that can blow cylinder heads off the block in pieces or blow the block in half.

* Dragsters twist the crank (torsionally) so far (20 degrees in the big end of the track) that sometimes cam lobes are ground offset from front to rear to re-phase the valve timing somewhere closer to synchronization with the pistons.

* To exceed 300mph in 4.5 seconds dragsters must accelerate at an average of over 4G's. But in reaching 200 mph well before 1/2 track, launch acceleration is closer to 8G's.

* If all the equipment is paid off, the crew worked for free, and for once NOTHING BLOWS UP, each run costs $1000.00 per second.

* Dragsters reach over 300 miles per hour before you have read this sentence.


Take care,
~Chris