

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#2 |
Registered Member
Join Date: May 1999
Location: Indiana
Posts: 512
|
![]() I think 3.55's would be great with a SC I had 3.08's stock and had gone with 3.55's before I installed the KB thinking they would be too much but then found myself wishing I had left the 3.55's in there. Last summer I installed a Z-spec world class tranny and was going to order another set of 3.55's but they talked me into 3.73's since my first and fifth gears were taller than stock... I have to admit that I LOVE my 3.73's!!! Of course my car pretty heavy and with me the full stereo and a tank of gas it is aproaching 3700 pounds... But I would say that 3.55's would probably still be a good choice. Good luck with whatever you decide!
![]() ------------------ 92GT all the free stuff and a few bolt-ons, lowered with Ebiach's and Koni's, Kenny Brown subframe connectors, lower G-brace and jacking rails. BBK upper and lower control arms, polyurethane bushings all around and Ken Bell blower, ram-air, 80mm mass air, etc. |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Best buy for superchargers | 89lxinwky | Windsor Power | 9 | 08-31-2001 01:59 PM |
Need tech. support on superchargers | Smokedawg | Windsor Power | 4 | 04-13-2001 06:08 PM |
Converter Stall and Superchargers | EXAM1999 | Modular Madness | 0 | 03-05-2000 04:21 PM |
Superchargers and gears | Ripper | Modular Madness | 3 | 01-27-2000 08:14 AM |