Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
08-14-2002, 08:36 PM
|
#1 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
You should never tap it on, and you should never try to use the original bolt to install it. You are lucky the crank threads didn't strip. Wnat you need to do is go to Home Depot (or any large hardware store) with your original bolt, and buy one that is two inches longer, a nut for it, and a large washer. Set the balancer on the crank, thread the nut all the way up the bolt, slip on the washer, and thread the bolt into the crank as far as you can. Start the nut and washer down the bolt until it becomes tight against the balancer. Then, while holding the bolt with one wrench, tighten the nut with another wrench. This will install the balancer safely.
Take care, ~Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Harmonic Balancer Suggestions | jim_howard_pdx | Windsor Power | 5 | 02-28-2008 11:32 AM |
| Harmonic Balancer | 95_MUSTANG_95 | Windsor Power | 3 | 05-28-2003 09:48 AM |
| 94Gt harmonic balancer installation | jay5liter | Windsor Power | 1 | 05-26-2003 03:10 AM |
| Harmonic Balancer Installation | 90LxDroptop | Windsor Power | 3 | 12-30-2002 03:36 AM |
| Harmonic balancer trouble | 90LxDroptop | Windsor Power | 4 | 12-03-2002 10:49 AM |