Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-15-2002, 03:34 PM
|
#2 |
|
Mustang Addict
Join Date: Jan 2001
Location: McKinney, TX
Posts: 1,294
|
The alignment could definitely be a factor. Sometimes a wheel out of balance can cause some bad vibrations and noise at certain speeds, but probably not just while braking or turning right.
I also have a '79 Pace Car replica. Does yours have the 302 or the turbo 4? Mine was pitifully slow with the stock 302 and 2.47 gears- high 16s in the 1/4 mile with those 130 mean horses. I've got the whole Edelbrock Performer setup and true dual exhaust now with 3.08 Trac-lok and it runs solid 13s on street tires.
__________________
Strike down the unroadworthy! 2000 GT Atl. Blue: '03 Cobra motor - 465rwhp/473rwtq, T-56 6-speed, full MM TA/PH & tubular K-member suspension, Saleen body, 17" Torq-Thrust II's, M/T ET Street radials, and lots more '94 Rio Red Cobra: All the bolt-ons, 3.73s |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help woth installing groundpounder coilovers with BBK caster camber plates | ciara | Windsor Power | 0 | 01-10-2004 01:08 PM |
| Always need caster camber plates? | squid | Windsor Power | 3 | 03-23-2003 11:52 PM |
| Steeda vs MM Caster Camber Plates | Mustangbelle306 | Corner Carvers Delight | 4 | 02-25-2002 05:47 PM |
| do i need camber caster plates | chatcher | Windsor Power | 5 | 11-04-2001 01:01 PM |
| CAMBER AND CASTER SPECS FOR LIGHT AUTO X? | LOCASH | Corner Carvers Delight | 2 | 01-06-2001 09:48 PM |