Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
08-17-2002, 01:20 PM
|
#1 |
|
Registered Member
Join Date: Dec 1998
Location: WI, U.S
Posts: 255
|
I've got a MSD Blaster 3 coil.
primary terminals showed a .3, but it would show it for a split second and go down to .1 and finally to no reading. Is that suppose to happen? I would leave the negative probe on pull off the positive and put the positive back on and it would do the same everytime... .3,.1, and nothing. Primary neg. terminal to secondary terminal showed 4.85 These readings are with all wires pulled from the coil. Time for a new coil? Is there any way to check the MSD ignition box to see if it's running up to par also?
__________________
91 LX - 10.5:1 pistons, ported 289 heads, Ultradyne 588 cam, Cobra upper/lower, MSD, JBA long tube headers, Flowmaster, Richmond 4:10, roll cage, monster tach...FUN!! 95 SHO - K&N filter |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TFI module vs Ignition module | teallighting | Windsor Power | 1 | 03-21-2004 03:38 AM |
| Best Ignition module and Coil? | 88fivepointoh | Windsor Power | 2 | 03-02-2003 01:23 PM |
| Fuel pump, Ignition module or something else? | MattwantsSpeed | Windsor Power | 16 | 07-07-2002 08:38 PM |
| Best place to mount an ignition module? | Blue Beast | Windsor Power | 4 | 03-16-2002 01:19 PM |
| Ignition Module | mustangLX92 | Windsor Power | 3 | 07-05-2001 05:18 AM |