Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-04-2002, 06:37 AM
|
#2 |
|
Registered Member
Join Date: Mar 2000
Location: Springfield, Ma, usa
Posts: 706
|
I would check the 10 pin connector. If your car hasn't been back to ford for the 10 pin connector recall I would bring it in. Its the black and white connector behind the intake. Ford made one side of the connector round, and the other side oval shaped. It results in a loose connection making for an idle problem similar to what you described. The jumper wire assembly takes car of that.
__________________
NewEngland Auto www.baystategearheads.com -91 Mustang Coupe, ex 4cyl (sold) -99 F150, 3" lift, 35" Procomps, Magnaflow exhaust |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| Idle creeps up question ?? | Mustang_289 | Windsor Power | 5 | 03-08-2002 12:49 PM |
| '95' 5.0 won't idle | prplhays | Windsor Power | 7 | 02-04-2002 10:57 AM |
| Problems with TFS engine combo..wont idle right and sputters when you give it throttl | dashapht | Windsor Power | 8 | 07-17-2001 12:23 AM |
| 2.3 idle | matt cook | Small Ponies | 1 | 08-02-1999 04:22 PM |