Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
09-04-2002, 04:36 PM
|
#1 |
|
Registered Member
Join Date: Oct 1998
Location: Rogers, MN
Posts: 2,089
|
You'd probably be better off using an angle grinder rather than a hacksaw. As already stated, make sure that the pipes still point downward when you're done.
__________________
351W 89 Mustang GT Convertible |
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 94 tailpipes on 92 | stanger9219 | Windsor Power | 3 | 07-12-2004 11:37 PM |
| Largest cam in 351W without cutting the pistons (Looking at AFR185s) | Fox Body | Windsor Power | 10 | 06-15-2003 12:39 AM |
| 3" H-Pipe and 3" Flowmasters into 2.5" tailpipes | NewAge 5.0 | Windsor Power | 1 | 02-26-2003 01:13 PM |
| is there a hp diffrence with tailpipes vs. turndowns | 93calcobra | Windsor Power | 28 | 01-20-2003 09:45 AM |
| Will any 2.5 inch tailpipes fit my flowmasters? | Hethj7 | Windsor Power | 5 | 07-10-2002 07:00 PM |