Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-12-2002, 03:57 AM
|
#8 |
|
Registered Member
Join Date: May 2001
Location: Oklahoma City OK USA
Posts: 236
|
the line tha burned up was a vacume line. I put a cap over the nipple on the intake and the car runs much better now. The can thing does have an eletrical connection, just a two wire harness. I still have the connection hooked up but im not shure if it matters because that vacume line is gone now. Anyone know wha i shoud do with this can and the charcoal thing??
__________________
90 GT 25th Anni. Did the AOD to T-5 swap, SPEC clutch, Steeda Tri-Ax shifter, BBK 2½ inch off-road H pipe, Flows, BBK 70mm TB/EGR, Ford Racing aluminim driveshaft, 3.55's, welded subframes, Ram Air, 3 core radiator, NOS dry kit 75 shot, and a K&N filter. 12.9 @ 108 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| stock GT40 head intake runner opening | mak375 | Windsor Power | 2 | 04-07-2003 09:14 PM |
| cobra intake on stock heads?? | scale | Windsor Power | 1 | 04-04-2003 02:51 PM |
| Is the stock intake a bottleneck for a street only setup? | Fox Hound | Windsor Power | 6 | 01-03-2003 03:30 PM |
| stock intake removal? - Carb | autoX | Windsor Power | 2 | 02-01-2001 01:30 PM |
| Trick Flow "R" Intake on a stock 88 5.0??? | BowTie Eater 5 Liter | Windsor Power | 3 | 01-15-2001 09:44 AM |