Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-14-2002, 09:21 AM
|
#8 |
|
Get down.....
Join Date: Apr 2001
Location: Room 103
Posts: 2,095
|
Chris and Andy
Chris. i was planning on putting an E cam in cause one of my lifters is bad, so it will give me and excuse to get a cam, but i dont think i am going to. If i can squeeze more power out of my stock compnents and all it will cost me is my labor and some gaskets, then i think it is worth it.
so i should go in increments and test cylinder pressure of each setting on the cam gear? the one with the highest is the best? is that what you want me to do? hey guys any suggestions of more power to squeeze out of my stock components would be helpful. i already know did all of the mods that i can think of so far. if retarding/advancing the cam will help, i will do that too.
__________________
Cobra brakes are on! Finally..... ------------------------------------------------ |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Another tire question | 96Saleen | Modular Madness | 6 | 02-10-2004 05:27 PM |
| A stupid question I hate asking about exhaust sound | jwboner | Windsor Power | 4 | 08-05-2003 05:55 PM |
| simple question | Lonzo | Classic Mustangs | 3 | 09-10-2002 09:37 AM |
| Mark VIII fan install question | FordGT145 | Windsor Power | 0 | 07-27-2001 08:15 PM |
| Newby here, I have a question on Odometers | mustangmama | Blue Oval Lounge | 3 | 03-03-2001 06:43 AM |