MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar Mark Forums Read

Notices


 
 
Thread Tools Rate Thread Display Modes
Prev Previous Post   Next Post Next
Old 09-15-2002, 10:13 PM   #2
Agent_4573
Registered Member
 
Join Date: May 2002
Location: New Jersey
Posts: 375
Default

It should read between .9 and 1.0 volts at idle and increase to over 4 volts at WOT. So your about .5 volts low. All you need to do is loosen the screws and turn it. Just turn the key on and adjust it with the volt meter attached. Turn it til you get ~.95 volts. This adjustment may screw up your idle. But first worry about getting the tps set up right, then worry about adjusting your idle. Make sure to reset the computer(disconnect battery, lights on for 15 minutes) after you adjust the tps and idle.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression.

If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout.

RICER HATERS CLUB MEMBER 87!
www.ricehatersclub.com
Agent_4573 is offline   Reply With Quote
 


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:50 AM.


SEARCH