Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-20-2002, 06:31 PM
|
#9 |
|
I need 110mph Trap Speed!
Join Date: Feb 1999
Location: So, CA
Posts: 4,315
|
I would check how complete the kit is. Be prepared to run into unexpected costs, and your going to have to beef up your fuel system.
You'll probably want some dyno time and a chip after you do the install as well. Skyler
__________________
2001 BMW M3 6spd 12.79@108 RIP ---- 1993 Notch w/ 98 4V 4.6 Fasttt... -1989 Saleen Mustang #406- 12.32@109 -1999 Black Cobra Coupe- JBA Shorties, Bassani Cat-X, Magnaflow 3", Pulleys, 85mm Pro-M, Ported Intake, Soild Rear w/ 4.30s, Tubular Front End, X2C arms, 13lb batt, few others. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Should you run a solid lift cam with stock bottom | ciara | Windsor Power | 1 | 10-23-2003 11:12 AM |
| Pro-M on stock motor? | NotchJohnson | Windsor Power | 3 | 03-23-2002 10:28 PM |
| Underhood Conical K&N vs. Stock Airbox with K&N | jimberg | Windsor Power | 11 | 08-31-2001 02:36 PM |
| How much HP is too much??? The key is stock bottom end... | Piston | Windsor Power | 10 | 07-30-2001 04:37 PM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |