

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#5 |
Registered Member
Join Date: May 1999
Posts: 5,246
|
![]() On a stock motor you're not gonna see much of any performance gain from any set of headers. The long tubes will require a new H-pipe built for them and are significantly more expensive than shorties.
Equal length shorties are probably never worth the money and hassel over unequals, and your motor will not benefit at all from any shortie header with a primary greater than 1 1/2". You'll just lose torque. |
![]() |
![]() |
Thread Tools | |
Display Modes | Rate This Thread |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
exhaust | Tikitoes | Modular Madness | 19 | 10-23-2003 04:18 PM |
Suspension ?--Bullitt, Eibach, Stock, or COMBO??? | rel3rd | Windsor Power | 3 | 10-15-2002 07:53 PM |
headers with stock exhuast? | gizmo83 | Windsor Power | 3 | 08-20-2002 09:30 PM |
BBK one-piece flange or MAC individual flange long tube headers. | Fox Body | Windsor Power | 10 | 04-03-2001 04:25 PM |
BBK shorties --> MAC Full Length | SmokeyDP | Windsor Power | 11 | 01-06-2001 09:04 PM |