Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
|
|
Thread Tools | Rate Thread | Display Modes |
06-14-2001, 01:17 AM
|
#4 |
|
Registered Member
Join Date: Oct 1999
Location: Cincinnati, Ohio
Posts: 1,575
|
I did a litte searching and this is what I found. Not sure if it what you are looking for but they said it's .125" radii on all rod and main journals.
------------------ 87 GT, 4 inch cowl hood,17x9 Cobra R's/255/45's,GT-40 heads,Crane 2031, Edelbrock intake, long tubes headers,h-pipe,Flows,BBK cold air, Mass air,70mm MAF, 1.7's, 1" spacer,underdrive pulleys,Pro 5.0, King Cobra, Adj. fuel Reg., Lakewood Lift Bars,50/50's,subframes, 4.10's. Best time 12.759 Best MPH 106.79 Best 60' 1.695 Visit my site at: http://www.geocities.com/cobrar93_2000/MyPage.html |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how much compresion with stock rods and crankshaft | cucho | Windsor Power | 5 | 02-08-2004 06:27 PM |
| eagle 5.400c rod ??? need to know by tomorrow!! | sn95gt19 | Windsor Power | 6 | 12-20-2002 12:31 AM |
| 2000 Mustang Crankshaft pulley | zzsmart | Modular Madness | 1 | 11-15-2002 08:28 PM |
| Stock Crank or Eagle Crank?? | Jwade | Windsor Power | 4 | 02-01-2002 11:34 AM |
| Crankshaft Pulley(Vibration Damper) Removal | Dray | Windsor Power | 8 | 10-23-2001 04:46 AM |