Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-01-2002, 09:23 AM
|
#6 |
|
2 Stangs in the Stable
Join Date: Apr 2002
Location: Baytown, TX
Posts: 1,209
|
I think I'm just going to nut up and buy a new distributor. Do the MSD distributor's come with a TFI module? How hard would it be to swap from EFI to carb, in hopes of doing away with the electronics? I know it won't pass emissions, but that is not a concern. How about the resistance values for the two coils? Also, how do you check them, pos to neg, pos to where the dist wire plugs up, ect?
Also, if I do buy a new distributor, how far do I have to turn the rotor past the #1 plug wire to get it to fall into place when the gears line up? Thanks Caymon
__________________
'90 GT Under construction Best E.T. = Fast @ High Speeds - OK So I Lie. So What!!!   04 F-150 STX 4.2L 5 spd Rice Haters Club Member #128 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine is not getting spark? Please HELP! | Patrick302 | Windsor Power | 4 | 06-20-2004 10:20 PM |
| replaced spark plugs, now car runs like **** | cavdo | Modular Madness | 10 | 12-31-2002 05:49 PM |
| spark probs... | mustang79 | Windsor Power | 1 | 08-18-2002 10:35 AM |
| No spark=Engine not running..How can I tell if I got spark??? | Stang_ROTY | Windsor Power | 11 | 10-24-2001 03:18 PM |
| Have Fuel NO SPARK! | Tony91LX | Windsor Power | 5 | 06-21-2001 05:55 AM |