Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-06-2002, 02:54 PM
|
#2 |
|
Registered Member
Join Date: Apr 2002
Location: Evansville, IN
Posts: 98
|
I would go ahead and replace the carrier barrings and races while you were at it. Especially if they have any pitting. There are also two barrings and a seal on the pinion gear as well. It will set you back about $60 for all the bearings races and seal. They are really easy to change too.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Post-Rebuild tranny noise question!! | NoSlow5.0 | Blue Oval Lounge | 1 | 04-19-2004 08:56 PM |
| rear end making tons of noise after 4:10 install | moponys | Modular Madness | 2 | 03-19-2003 03:15 PM |
| need advice on axle noise | taurus3298 | Windsor Power | 1 | 10-09-2002 08:57 PM |