Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-07-2002, 05:07 PM
|
#22 |
|
Registered Member
Join Date: Mar 1999
Location: va
Posts: 35
|
Overlap means that both the intake and exhaust valves are open at the same time. If a cam has overlap it means that it will develop power in a higher rpm range depending upon how much the overlap is. The overlap for the "B" is less than 4 degrees whereas the "e" is 0. The more the overlap the more power in a higher rpm range and the less streetability.
If you can get a copy of October 1999 issue of 5.0 mag. there is a great article on page 69. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Optima battery selection | PWR_RYD93 | Windsor Power | 12 | 01-12-2004 01:09 PM |
| Intake selection with a 383/408 stroker | Capri306 | Windsor Power | 12 | 05-03-2002 10:12 PM |
| Gear Ratio Selection | Green96GT | Modular Madness | 4 | 07-19-2001 11:40 AM |
| wheel and tire selection | Danielz9 | Corner Carvers Delight | 1 | 05-04-2000 08:38 AM |
| Gear selection | Grulla | Corner Carvers Delight | 1 | 03-13-2000 09:04 AM |