Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-10-2002, 01:29 PM
|
#11 |
|
Registered Member
Join Date: Oct 1998
Location: Pitts. Pa. USA
Posts: 61
|
351W
I am running a similar setup in a 87 stang. Right now have an AOD but going to C4. My carb has no choke, vacumn secondaries, 80 jet in the secondary and 76 in the primary. In cool weather could probably go with 78 in the primary. I think the vac. with the quick change spring kit is the way to go on an automatic. I am running the spring for about 2600-2700 rpm secondary. Also, have the 50 pumper. If you have the fuel plate in the secondary get the kit to allow you to change the secondary jets. Watch out to be sure the bowl has a good seal as mine a small burr that had to be ground off as it was sucking air in the secondary.
Good Luck |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351W Heads on a 87 302 Block | NitroNixon | Windsor Power | 5 | 05-08-2003 09:29 PM |
| 351W heads on 289 stock engine | sleeperstang | Classic Mustangs | 5 | 11-21-2002 08:35 PM |
| Where to find 351W SVO | GodStang | Windsor Power | 0 | 10-11-2002 02:04 PM |
| 351W in a Fox body | greydan | Windsor Power | 4 | 07-03-2002 02:33 PM |
| HP #'s from a built 351W versus FMS 351 versus stroker | stroker393 | Windsor Power | 0 | 03-09-2001 10:24 AM |