Filling a engine with WD-40?? make it new again?

Francismaximus · 06-17-2001, 07:24 AM

Take off the intake (lower) and valve covers. Take off rockers, remove pushrods (inpect for straightness), inspect lifters for missing clips etc or wear, ck those cam lobes while your at it (5.0's ussualy dont wear much from the rolers) and change the lifters. Additives? Water in the intake that I know works to break up carbon and reapiar carbon knock. Oil additives usually and I sau usually so I don't start a flame war tend to swell and eat up gaskets due to the cleaners and chemicals they are composed of. Say like diesel or keosene (yeah alot of companies use it) put a o ring in some of it and watch it swell. Anyway when you get the lowr off you may have sludgebuildup under the lowr in take and in the lifter valley scrape it clean it spray it with brakekleen after all is assembled drain oil relly well change oil. And enjoy another 50k on your 5.0. My 86 lincoln went 255K before I sold it yes sold. With just oil changes and at 166K needed an oil pump.

------------------

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mustang engine I.D. Help	hotrod5125	Classic Mustangs	14	11-11-2004 07:53 PM
raced a Supra Twin Turbo	Stang35th	Stang Stories	63	08-23-2003 12:36 AM
Need to sell Engine and tranny	OnMy3rdStang	Blue Oval Lounge	5	03-09-2003 10:29 PM
Stupid Question?	SilverGT02	Modular Madness	4	07-06-2002 11:01 AM
Very bad experience with Engine Dynamics of San Jose CA	JAGraff	Small Ponies	0	05-12-1999 02:27 AM

06-17-2001, 07:24 AM	#1
Francismaximus Registered Member Join Date: May 2001 Location: Harriman, NY, USA Posts: 11	Take off the intake (lower) and valve covers. Take off rockers, remove pushrods (inpect for straightness), inspect lifters for missing clips etc or wear, ck those cam lobes while your at it (5.0's ussualy dont wear much from the rolers) and change the lifters. Additives? Water in the intake that I know works to break up carbon and reapiar carbon knock. Oil additives usually and I sau usually so I don't start a flame war tend to swell and eat up gaskets due to the cleaners and chemicals they are composed of. Say like diesel or keosene (yeah alot of companies use it) put a o ring in some of it and watch it swell. Anyway when you get the lowr off you may have sludgebuildup under the lowr in take and in the lifter valley scrape it clean it spray it with brakekleen after all is assembled drain oil relly well change oil. And enjoy another 50k on your 5.0. My 86 lincoln went 255K before I sold it yes sold. With just oil changes and at 166K needed an oil pump. ------------------