Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-16-2002, 10:42 PM
|
#6 |
|
Registered Member
Join Date: Jan 2002
Location: Mt. Prospect,IL
Posts: 474
|
Its silly that a 50.00 dollar part is such a pain in the *** to install and so expensive to be put in by someone else
__________________
87-ford-mustang-SOLD! mods: 3:73's, off road h-pipe, b303 cam in gt- 40 motor w/ Power Plus intake, edelbrock 70mm tb & egr spacer, 72mm C&L, bbk long tubes, tremec tranny, centerforce dual friction clutch, upr and lwr CA's 255lph FP and soon more to come.... when i have money again SOME ADVICE Don't do burn outs in reverse it is very expensive New times with dead hook on dr's 13.27@103 with 2.0 60 foots w/100lb system Fastest time to date: 12.8@113 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Heater Core leaking already! | 429mustang | Windsor Power | 2 | 07-30-2004 09:05 AM |
| should i tackle a 96 T-bird heater core? | fiveohpatrol | Windsor Power | 0 | 04-14-2002 06:50 PM |
| Who can help? Question about EGR spacer and heater... | Bad89stang | Windsor Power | 8 | 11-29-2001 12:27 PM |
| Smoke/steam from vents. Heater core?? | RMARIANI | Windsor Power | 9 | 08-02-2001 01:23 PM |
| Heater Core Removal | 65mustang-man | Classic Mustangs | 2 | 09-17-2000 01:32 AM |