Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-16-2002, 10:53 PM
|
#3 |
|
Registered Member
Join Date: Dec 1999
Location: Warrington, PA
Posts: 694
|
Well he has a stout little package there, but in the 1/8th its definately all you with that nitrous torque. With his power to weight ratio, I would think he has a possible mid-low 13 sec car with really good traction.
Most the turbo imports around here don't really start pulling till the top of 2nd gear. By that time, in an 1/8th miles race, I would definately put my money on you. You have the torque advantage to pull you out through first, so don't get over excited and smoke'em. In a 1/4 run I would expect it to be a close run. Throw some race gas in the tank and give the 100 shot a whirl if you are that worried about losing.
__________________
'97 T-bird LX 4.6L 2V, auto SVO heads/intake, Vortech T-trim, front mounted intercooler, blower cams, Cobra crank, Manley H-beam rods, JE pistons, Aeromotive fuel system w/ 42# injectors, and much more No times yet |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turbo vs SC Sounds like good advice | mustardjohn | Small Ponies | 0 | 11-16-2003 05:21 PM |
| Ran a turbo Integra, a Grand National, and two bikes!!! | WhiteT78Supra | Stang Stories | 23 | 07-19-2002 07:21 AM |
| Turbo in n/a 2.3? | pxcr_600 | Small Ponies | 1 | 06-21-2002 12:20 PM |
| What's needed to build a Turbo 5.0L? | Gautam | Windsor Power | 1 | 06-07-2001 05:34 PM |
| How do I know if the turbo is working? | Trevor | Small Ponies | 3 | 07-20-1999 10:35 PM |