Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-22-2002, 09:31 AM
|
#12 |
|
Registered Member
Join Date: Apr 2002
Location: Kingston, Ontario
Posts: 351
|
if I were you I would cut that whole section of wire out and get some new wire
soldering and heat shrink tubing is the best then you won't have problems with it again
__________________
 '88 lx, Black on Black, check it out here Spent all my money on school, what a dumb mistake I'm old enough to know better, but still too young to care. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Battery..Solenoid..Starter problem | abesmith69 | Windsor Power | 6 | 04-09-2003 09:39 AM |
| Battery Disconnect and ECM Reset | mimicons | Windsor Power | 1 | 02-18-2003 11:20 AM |
| Battery is dead after pulley install?!? | Stang_Crazy | Windsor Power | 16 | 02-07-2002 09:39 PM |
| Battery not charging | Mustang_289 | Windsor Power | 8 | 01-04-2002 07:07 AM |
| battery removal | 82 GT | Windsor Power | 2 | 03-18-2001 04:40 PM |